While I am not disputing that the "bike" can get off the ground, which only a single photograph shows btw, I am disputing the ability of this project to "get off the ground."
The quotation marks refer to it as a figure of speech.
Since you questioned my assertions, let me explain my views a bit more.
First and foremost, the large twin rotors have a variety of problems, by design, that have nothing to do with the safety concerns of the spinning blades.
(Which is a small matter to design proper safety mesh)
The twin rotors design does give it a nice amount of lift/ thrust, but it does not give it stability or maneuverability, two big things that are needed in a "hover bike."
Having just two rotors that must provide lift, stability and thrust all at the same time is just too risky.
Four rotors would be much better for this, two dedicated for lift and stability and two dedicated to thrust and stability.
However, to do this the lift to weight ratio would probably be less. (So lower top speed, acceleration and ceiling)
All this glorified "hover bike" is at the moment is a pair of giant fans powered by a big BMW engine with a seat in the middle.
Its actual capacities as a "hover bike" are questionable at best, in my opinion.
That is not to say that this guy after ten years of tweaking the design won't come up with a better design that could lead to a real prototype, or that noone will ever make a "hover bike."
But, I can say with confidence, from what I know about physics and aerodynamics, this particular design has deep flaws,
Turgus wrote:that requires a redesign from the ground up.
The best design for a "hover" vehicle that I have seen so far is the Skycar, yours for around $100,000 available sometime around 2012.
They plan on doing a media only demonstration on October 11, 2011 in Vacaville, CA.
Take a look at their website.
http://www.moller.com/index.php?option= ... &Itemid=57
~Good Day and Good Hunting~