WoW Petopia Community

With the ground surface being so deep, can npcscan still detect GC by flying right at water level, or do you have to swim down closer to the surface?

Well thats ok, right as I finished this, I went down to the surface and got him, but if you know if would be good to notify others, cuz flying above would be way faster.

Kolorath has scared the life out of me several times, and i literally jumped in my chair first time I saw him.

I would like to encourage others who are interested in taming this rare npc, Ghostcrawler. On Khadgar realm (Euro), I found him eventually at co-ords ± 12.8/83.4, using NPC Scan as well as /tar ghostcrawler (over reaction, but I was desperate!). Time of spawn was close to mid-day; I found him at 12:03. He really isn't that difficult to tame, did knock my health down to just below a third, but I was in no danger of dying, even with my totally rubbish gear. So, take heart - keep looking and good luck!
Happy hunting!
Kathy aka Tippie
27May2011

You don't really need npcscan for Ghostcrawler. As he and the elite pat are the only ones on the reef, just use track beast.

GormanGhaste wrote:You don't really need npcscan for Ghostcrawler. As he and the elite pat are the only ones on the reef, just use track beast.

But Ghostcrawler phases out, so it is not possible to detect him on either track beasts or track hidden when he gets invisible, so might be a good idea to have NPCscan or silver dragon to check for him just in case.

Shirubia wrote:But Ghostcrawler phases out, so it is not possible to detect him on either track beasts or track hidden when he gets invisible, so might be a good idea to have NPCscan or silver dragon to check for him just in case.

I thought he wasn't detectable by npcscan when phased out; I could be wrong though.

GormanGhaste wrote:

Shirubia wrote:But Ghostcrawler phases out, so it is not possible to detect him on either track beasts or track hidden when he gets invisible, so might be a good idea to have NPCscan or silver dragon to check for him just in case.

I thought he wasn't detectable by npcscan when phased out; I could be wrong though.

Not sure if it does, but the time I found the ghostcrawler I tamed, clicking in the npc scan button didn't targeted it until about 5-8 seconds later, when it rephased.

He isn't. I found him, followed him, bloop, then had to find him again. So I don't think it can grab him if he's phased.